10
Maintenance
- Before performing maintenance work switch off the Power Cutter (27) and
pull out the plug cap.
- Always check the Power Cutter before using it to make sure that it is in good
working order. In particular, make sure that the cutting disc is properly mounted.
Make sure that the cutting wheel is undamaged and suitable for the job it will be
used for.
- Operate the Power Cutter only at a low noise and emission level.
For this ensure the carburetor is adjusted correctly.
- Clean the Power Cutter regularly.
- Check the fuel tank cap regularly for good sealing.
Observe the accident prevention instructions issued by trade associations
and insurance companies. NEVER make any modications to the Power
Cutter! You will only be putting your own safety at risk!
Perform only the maintenance and repair works described in the instruction
manual. All other work must be carried out by DOLMAR Service (28).
Use only original DOLMAR spares and accessories.
The use of non-DOLMAR spares, accessories, or cutting discs increases the
risk of accident. We cannot accept any responsibility for accidents or damage
occurring in association with the use of cutting discs or accessories other than
original DOLMAR.
27
28
29
SERVICE
First aid (29)
Make sure that a rst aid kit is always immediately available close by. Immediately
replace any items used from the rst aid box.
When calling for help, give the following information:
- Place of the accident
- What happened
- Number of injured people
- Kind of injuries
- Your name!
NOTE:
Individuals with poor circulation who are exposed to excessive vibration may
experience injury to blood vessels or the nervous system.
Vibration may cause the following symptoms to occur in the ngers, hands or wrists:
“Falling asleep” (numbness), tingling, pain, stabbing sensation, alteration of skin
colour or of the skin.
If any of these symptoms occur, see a physician!
To Next Page
Loading...