Domino D320i Red User Manual

OPERATION
3-28 L025317 Issue 5 July 2014
Conditional Printing
For conditional printing the digital inputs needs to be configured. While the
condition mask only specifies which inputs to look at, the condition value
needs to be set according to the exact state the input shall have in order to
mark the object.
Both condition mask and condition value are calculated by the sum of the
binary representation value of the inputs to be used:
•User Input A - 1
•User Input B - 2
•User Input C - 4
•User Input D - 8
•User Input E - 16
•User Input F - 32
•User Input G - 64
Examples
• An object shall only be printed if user input A is high then mask=1/
value=1
• An object shall only be printed if user input A is low then mask=1/
value=0
An object shall only be printed if user input A is low and user input B is high
then mask=3/value=2

Domino D320i Red Specifications

General

Print Technology	Thermal Transfer
Operating Temperature Range	5°C to 40°C
Ribbon Width	4.33" (110mm)
Ribbon Length	300 m (984 ft)
Connectivity	USB, Ethernet, Serial