12 of 27 PSS5000/INGU/805799/09
PSS 5000 – Installation Guide
2 Installing the PSS 5000 Forecourt Controller
6. Select 5. Setup 5.6. Communication 5.6.1. TCP/IP.
The
TCP/IP window appears. This shows the current details for both Port
41 and Port 42.
7. Do one of the following:
• (
Recommended) To assign a static IP address, go to step 8.
• To assign a dynamic IP address, select
Enable DHCP Client and go to
step 9.
8. Select Port 41 and type in the required values for:
•
IP Address
• Subnet Mask
• Default Gateway
Note:
Set the IP address so that Port 41 and Port 42 belong to separate
subnets.
To ensure that the information provided here is correct, you should ob-
tain the necessary details from your System Administrator.
9. Click to apply the changes.
After the IP address has been changed, the FCC Web Application is also
accessible from the LAN. You are now ready to proceed to the next step in
the process.
See Also
• ‘IP Address Assignments’ on page 9
To Next Page
