17
Donaldson Company, Inc.
Hopper
1. Attach legs and cross bracing to hopper using 3/8-
16 x 1-in bolts, washers, and nuts as shown. Cross
braces can be installed to allow front or back hopper
access.
Note: The 5-gallon pail hopper does not require
cross bracing.
2. Position the hopper and leg assembly on the
foundation’s anchor bolts and fasten securely.
3. Apply 1/4-in diameter rope-type sealant to the
hopper’s top flange.
4. Lift cabinet over hopper and leg assembly and lower
slowly.
5. Secure with bolts, washers, and nuts supplied.
Hopper to 5-Gallon Pail Assembly
(Size 90 hopper is welded to cabinet)
cabinet
see Detail A
leg
hopper
cabinet
sealant
hopper
3/8-in flat washer
3/8-16 x 1-in bolt
Detail A
Optional Equipment
Hopper Access
Completely turn off and lock out
all dust collector and ancillary
equipment before accessing the inside of the
hopper.
Dust may build up behind hatch and fall out
when opened. Position yourselft so dust will
not hit you.
Most dusts present safety and health hazards
that require precautions.
Wear eye, respiratory, head and other
protective equipment suitable for the type of
dust.
To Next Page
Loading...
