Need help?Do you have a question about the DoorHan SWING-5000 and is the answer not in the manual?
Physical dimensions and component diagrams for SWING-3000/5000 models.
List of all components included in the SWING gate operator kit.
Pre-installation checks for gate leaves, structure, and supporting posts.
Diagram detailing the basic cable layout for a pair of motors.
Wiring diagram for low voltage accessories and the tuned antenna.
Instructions for welding and attaching fixing plates and rear brackets to piers.
Guide to attaching the rear bracket with adjustable holes for gate motor installation.
Procedure for attaching the front bracket to the gate wing ensuring alignment.
Steps for mounting the gate operator motors onto the prepared brackets.
How to adjust the microswitch for setting the gate's open limit position.
Instructions for ensuring motors are earthed and fitting the control panel.
Detailed technical specifications for the SWING gate control board.
Identification of LEDs, terminals, and fuses on the control board.
Details on connecting accessories to terminal board J1.
How to program motor force and anti-crushing safety using microswitches.
Selecting function logic, closing/opening delays, and photocell behavior.
Configuring fail-safe operation and reverse stroke for electric locks.
Procedures for simple and advanced learning of gate operating times.
Step-by-step guide for simple gate operational time learning.
Detailed procedure for advanced learning of gate operating times.
Table showing LED status relative to input status for system checks.
To Next Page
General