31
1800-060 Issued 7-19
Version A
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press (beep).
3. Press (beep) again. This CANNOT be UNDONE!
4. Repeat steps 2 and 3 to delete additional phone numbers.
5. Press together to end this programming sequence (beeeeeep).
0
0
0
? ? ? ?
1
0
? ? ? ?
1
0
1 9 0 4 3 5 9 6 6 7 9
1. Press and enter your four-digit MASTER CODE (beep).
2. Choose and enter a directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press (beep).
Note: Use the log tables in back of this manual to keep track of names, phone numbers and directory codes.
3. Enter the phone number (Up to 16-digits, but less digits will be accepted) for the chosen directory code, then press (beep).
Note: Entering the anywhere in the phone number (multiple #’s can be used) will cause the dialing sequence to pause
(1-9 seconds) if necessary, whatever was programmed in section 3.2.2.
In this programming sequence, the directory codes and phone numbers (up to 16 digits) will be programmed into the system.
Be sure you have programmed the directory code length that you desire as described in section 3.2.1. Changing the directory
code length (Section 3.2.1) AFTER programming the telephone numbers will ERASE ALL the phone numbers and directory
codes that have been previously programmed in.
If you use directory codes 0, 00, 000, 0000 and/or 1, 01, 001, 0001 remember that the talk time for these directory codes are
factory set to the maximum and cannot be changed. Use these directory codes to program management or emergency phone
numbers, which generally require longer conversation periods.
Important: The factory default setting is 16-digit phone numbers. Section 3.2.8:
*
45 7-digit phone numbers MUST NOT have
been reprogrammed ON (1 - YES). If it has been, section 3.2.9
*
44 16-digit phone numbers MUST be reprogrammed ON (1 -
YES) before proceeding and ALL previously programmed phone numbers WILL be eased.
3.2.3 Programming Phone Numbers - Up to 16-Digits
Note: The phone system can be programmed to store up to 1000 phone numbers ONLY when using sections
3.2.8 - 3.2.13 (7-Digit Phoner numbers and area codes) programming, but this requires more programming for
each phone number used, setting up individual area code reference numbers etc. and is not recommended.
Example: Phone number 1-904-359-6679 needs to be dialed with a pause after the 1.
600 (Factory Default) 1000 (using sections 3.2.8 - 3.2.13)
Max Phone Number Capacity
Important Note: If you make a mistake while programming, press keys at the same time
to escape from programming no matter how much has been completed, then begin again at step 1.
4. Repeat steps 2 and 3 to enter additional directory codes and phone numbers.
5. Press together to end this programming sequence (beeeeeep).
Programming:
This programming sequence is used to delete a SINGLE phone number under a known directory code.
Note: This programming will NOT work for 7-Digit Phone Number programming, use section 3.2.13.
3.2.4 Deleting Individual Phone Number
To Next Page
Loading...
