How to fix DTMF tones heard 15 seconds after call is answered on DoorKing 1814?
If you hear DTMF tones 15 seconds after a call is answered on your DoorKing Intercom System, the CALL UP feature is likely enabled. To resolve this, reprogram the feature to turn it off (refer to section 3.2.3).
How to resolve postal switch will not activate relay on DoorKing 1814 Intercom System?
If the postal switch is not activating the relay on your DoorKing Intercom System, ensure that: * The wire-tie has been clipped off the postal switch. * The relay has been programmed for postal switch input (refer to section 3.2.7).
How to resolve relay activates but gate operator will not open on DoorKing Intercom System?
If the relay activates but the gate operator does not open on your DoorKing Intercom System, consider the following: * Reprogram the relay strike time for a longer period (refer to section 3.2.4). * Check the wiring to the gate operator. * Inspect the gate operator itself.
Why DoorKing Intercom System rotary dial 9 will not activate relay?
If rotary dial 9 is not activating the relay on your DoorKing Intercom System, try adjusting the click sensitivity (refer to section 4.3).
Why DoorKing 1814 touch-tone 9 will not activate relay?
If touch-tone 9 is not activating the relay on your DoorKing Intercom System, try the following: * Re-program tone-open number to 9 (refer to section 3.2.6). * If the resident phone emits a short pulse rather than a long tone, press 9 twice in rapid succession. * Try using another phone that is known to work. * Lower the speaker volume (refer to section 4.1) and re-adjust feedback (refer to section 4.2).
General| Brand | DoorKing |
|---|---|
| Model | 1814 |
| Category | Intercom System |
| Language | English |
Essential guidelines for installing the system, including general procedures and precautions.
Detailed steps for installing the system's memory chips, crucial for proper operation.
Instructions for installing a postal lock, enabling mail carrier access to the entry system.
Overview of wiring requirements, including wire types, grounding, and conduit considerations.
Details the function of each terminal connection on the main circuit board for wiring.
Illustrates typical wiring configurations for controlling doors or gates using system relays.
Introduces programming methods and provides essential tips for successful system configuration.
Covers fundamental programming settings like master code, system mode, and strike times.
Guides on how to program names, user messages, and instruction messages into the system.
Detailed instructions for entering resident phone numbers, names, and directory codes.
Covers the programming and management of four-digit entry codes for resident access.
Instructions for adjusting the speaker volume for clear communication.
Guidance on adjusting the audio feedback for optimal microphone performance.
Steps to adjust the click sensitivity for proper rotary dial or touch-tone recognition.
Procedure to adjust the LCD display contrast for readability.
Explains the function and use of the master code switch for system programming.
Guides guests on how to locate residents and communicate using the entry system.
Informs residents on how to grant or deny access to guests and use entry codes.
Details operations for system administrators, including remote access and hold-open commands.
Covers special operating features like line sharing, PBX connection, and 10-digit dialing.
Provides solutions for common problems, troubleshooting steps, and contact information for assistance.
Lists available accessories for the telephone entry system, such as mounting kits and test sets.
Provides log tables for recording programmed information like resident data and system settings.
To Next Page
