A Series Diesel Engine Fuel System 86
10mm
Remove the line clamp capscrew from the intake
cover.
14mm and 17mm
Remove the lines from the injection pump.
Note : Use two wrenches to prevent the delivery
valve holder from turning.
10mm
Assemble the lines in the reverse order of removal.
Torque Value: 11Nm [8 ft-lbs]
Warning : Do not bleed a hot engine as this could
cause fuel to spill onto a hot exhaust
manifold creating a danger of fire.
Start the engine and vent one line at a time until the
engine runs smoothly.
To Next Page
Loading...
