A Series Diesel Engine Introduction
7
Definition of Terms
The following is a list of guidelines for each procedure in the “repair Sections” of the Troubleshooting and Repair
Manual. The procedure will be given first; followed by a definition o the step or steps involved.
Check
Inspect
Test
Adjust
Visually
Inspect
Remove
Clean
Disassemble
Repair
Note
Replace
Install
Star Pattern
Torque
Sequence
Examine a component or system for damage, excessive wear, accuracy, safety, or
performance.
Examine a component or dimension to make sure it meets the required specifications.
Check or compare the performance of a component or system to established
specifications.
Complete the necessary steps to set or adjust the component, assemblies, or system in
the required setting or position.
Look for any obvious damage or problem.
Take off a component or assembly
Remove dirt, grease or other contamination.
Take the component or assembly apart.
Restore a component or assembly to a serviceable condition within the established
specifications.
Only the easiest and simplest repairs will be made to a component or assembly. If a
component or assembly must be rebuilt; it must be replaced with a new or Cummins
Diesel Recon, Inc. replacement or be rebuilt at a Cummins authorized repair location.
Install a new, properly rebuilt, or Cummins Diesel Recon, Inc. component or assembly
in place of one which is removed.
Place a component or assembly in the correct position.
To Next Page
Loading...
