Doosan A2300 - Cylinder Head and Gasket

A Series Diesel Engine Base Engine Components 207
Caution : Do not measure clearance between the cap
and crankshaft.
Measure the side clearance between the connecting
rod and crankshaft.
Side Clearance Limits
Min Max
0.15 mm
[0.006 in]
0.35 mm
[0.0138 in]
Install the suction tube and oil pan (refer to page 6-19).
Cylinder Head and Gasket –
Installation
Caution : Make sure the gasket is correctly aligned
with the holes in the cylinder block.
The cylinder block and head must be clean and dry.
Position the gasket onto the dowels.
Carefully, put the cylinder head onto the gasket and
cylinder block.
Note : Make sure the cylinder head is installed onto
the dowels in the cylinder block.