Maintenance Section
213
Radiator Cap - Clean, Change
Clean Pressure Cap
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
1. Remove the radiator cap slowly to relieve
pressure.
2. Inspect the cap for damage, deposits or foreign
material. Clean the cap with a clean cloth or
change the cap as necessary.
3. Install the cap.
Clean Outside of Radiator Core
WARNING
Pressure air can cause personal injury.
When using pressure air for cleaning, wear a
protective face shield, protective clothing and
protective shoes.
The maximum air pressure must be below 205
kPa (30 psi) for cleaning purposes.
Compressed air, high pressure water or steam can
be used to remove dust, leaves and general debris
from a radiator. Clean as required by condition of
radiator.
The use of compressed air is preferred.
Carriage Roller Extrusion - Adjust
1. Set the mast vertical.
2. Lower the carriage completely.
3. On full free lift and full free triple lift models, the
bottom of the inner mast must be flush with the
bottom of the stationary mast.
4. Measure the distance from the bottom of the
inner upright to the bottom of carriage bearing.
5. The measurement (A) must be as follows in
Chart below.
Height of carriage roller extrusion (A)
STD mast FF mast FFT mast
D60/70S-7 (3 Speed)
23 - 26
D80/90S-7 (3 Speed)
42 - 42
To Next Page
