Maintenance Section
237
Every 1000 Service Hours or 6 Months
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.
Air Intake System - Change
Changing Primary Element
See topic, “Air Intake System - Check, Clean” in
“Every 500 Service Hours or 3 Months”.
Changing Secondary Element
Replace the secondary element after the primary
element has been cleaned three times or yearly.
1. Remove the primary air cleaner element. See
topic “Servicing Filter Element”. Clean the inside
of the air cleaner housing and cover.
2. Remove the secondary element. Inspect the
gasket between the air cleaner housing and the
engine inlet. Replace the gasket if it is damaged.
NOTICE
Always replace the secondary element. Do not
attempt to reuse it by cleaning.
3. Install a new secondary element. Install a new or
cleaned primary element. Install the cover.
Tighten the latches.
4. Start the engine and observe the air cleaner
service indicator. If the indicator shows RED after
installing a new secondary element and a
cleaned primary (outer) element, replace the
cleaned primary filter with a new element.
5. Stop the engine. Close the hood and seat
assembly.
Carburetor (LP - Gas Engine Only)
- Adjust, Clean
If the engine is hard to start or the exhaust is
smoking, the carburetor may need cleaning and
adjusting.
Before adjusting the carburetor make sure the
engine is at normal operating temperature. Park the
lift truck with the forks lowered, parking brake
applied, transmission in neutral and the engine
stopped.
For the complete procedure and specifications for
your specific engine, see the "Service Manual".
To Next Page
Loading...
