Operation Section
85
Automatic Transmission Switch
(3 Speed Only)
Automatic speed range:
. FORWARD: 3 speeds.
. REVERSE: 3 speeds.
1. Set this switch at "1" (Auto 2
nd
), the speed will be
controlled at the 2
nd
and 3rd gear ratio
automatically, according to the load and engine
speed.
2. Set this switch at "2" (Auto 1
st
), the speed will be
controlled at the at the 1st, 2nd and 3rd gear
ratio automatically, according to the load and
engine speed.
3. When this switch is at '3'(manual) position, travel
mode is switched to “MANUAL” and allows
operator to choose speeds manually.
Inching Switch(3 Speed Only)
This switch changes over the modes of the inching
control pedal, inching and no-inching.
1. In the "1" position, “NO INCHING” mode is
selected. In the "NO INCHING" mode, the
inching pedal is not operable but braking with the
inching pedal is available.
2. In the "2" position, “INCHING” mode is selected.
In the "INCHING" mode, normal inching
operation is available using the inching pedal.
NOTE: When driving a middle or long distance
without using the inching function, set this
switch to "1" position to prevent the
transmission clutch pedals from
unnecessary wear or overheat.
To Next Page
Loading...
