20
DESCRIPTION OF CONTROLS
CAUTION
The module may instruct an engine start event due to
external influences. Therefore, it is possible for the
engine to start at any time without warning. Prior to
performing any maintenance on the system, it is
recommended that steps are taken to remove the
battery and isolate supplies.
Note: The following descriptions detail the sequenc-
es followed by a module containing the stand-
ard ‘factory configuration’. Always refer to
your configuration source for the exact
sequences and timers observed by any
particular module in the field.
Control of the module is via push buttons mounted on
the front of the module with Stop/Reset Mode ,
Manual Mode , Test Mode (DSE6020 MKII
Only), Auto Mode and Start functions. For
normal operation, these are the only controls which
need to be operated. Details of their operation are
provided later in this document.
To Next Page
