Maintenance Operating & Maintenance Manual
97
Completely drain the receiver/separator system including the piping and oil cooler by removing
the drain plug(s) and collecting the used oil in a suitable container.
Replace the drain plug(s) ensuring that each one is secure.
NOTE: If the oil is drained immediately after the machine has been running,
then most of the sediment will be in suspension and will therefore drain more
readily.
Some oil mixtures are incompatible and result in the formation of
varnishes, shellacs or lacquers which may be insoluble.
NOTE: Always specify Pro-Tec
TM
oil for use at all ambient temperatures above
-23
°
C.
Compressor Oil Filter Element
Refer to the SERVICE/MAINTENANCE CHART in this section for service intervals.
Running Gear Wheel Bearings
Wheel bearings should be packed with grease every 6 months. The type of grease used
should conform to specification MIL-G-10924.
To Next Page
Loading...
