Operating & Maintenance Manual General Arrangement
38
Lubricating Oil Specification
LUBRICATING OIL SPECIFICATION
(for the specified ambient temperatures).
ABOVE -23°C(-9°F
)
Recommended: Pro-Tec
TM
Approved: SAE 10W, API CF-4/CG-4
BELOW -23°C(-9°F)
Mandatory: Performance 500
Pro-Tec
TM
compressor fluid is factory-fitted, for use at all ambient temperatures above -23°C(-
9°F).
NOTE: Warranty may be extended only by continuous use of Pro-Tec
TM
and
recommended oil filters and separators.
No other oil/fluids are compatible with Pro-Tec
TM
No other oils/fluids should be mixed with Pro-Tec
TM
because the resulting mixture could cause
damage to the airend.
In the event that Pro-Tec
TM
is not available and /or the end user needs to use an approved
single grade engine oil, the complete system including separator/receiver, cooler and
pipework must be flushed clear of the first fill fluid and new oil filters installed.
When this has been completed, the following oils are approved:
a. for ambient temperatures above -23°C(-9°F), SAE 10W, API CF-4/CG-4
b. for ambient temperatures below -23°C(-9°F), Performance 500 only.
Safety data sheets can be obtained on request from the lubricant supplier.
For temperatures outside the specified ambient range, consult your Portable Power
representative.
To Next Page
Loading...
