• Choose the correct projector model to connect to the unit using the “Projector model”
field(s).
• Select the model series for the projector from the drop-down menu on the right. The
projector model series varies for all projector manufacturers.
• Enter the Head IP address and then click the “test” button.
• If the "DLP Head Connection Test" fails, the IP address is invalid.
• Choose to either enable or disable the subtitles.
Note: If the user enables subtitles without the unit being connected to a projector, then the server
will not operate properly.
• Input the appropriate username and password. The username and password will vary for all
projector manufacturers.
• Check the Enabled check box at the top right corner of the GUI.
• Click the Save button to record the settings. A password confirmation page will appear.
Enter the password to save and record the settings.
6.6.2 Removing a Device or Projector
• To remove a device or projector, click on it in the left part of the Device Manager GUI.
• Click the Delete button (Figure 83).
______________________________________________________________________________________
D2K.OM.001822.DRM Page 71 of 177 Version 1.5
Doremi Labs
To Next Page
