EasyManuals Logo

Dorma ED 100 Mounting Instructions

Dorma ED 100
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
DORMA
DORMA
DORMA
23
ED 100/250
12. Parameterisation / Service
Theoperatorisreadyforoperationwithbasicparametersas
soonasthelearningcyclehasbeenperformedsuccessfully.
Thesystemalsoenablesyoutoadaptthedrivingparameters
totheprevailingconditionsandtoactivateextended
functions.Itisadvisabletoadapttheseparameterstothe
customer'srequirementsduringthecommissioningofthe
system.
< 3s Quit
> 3s Reset
< 3s
> 3s
LEARN
> 8s
Fact-Setup
> 3s
PRG
Parameters/Display Range Unit
factory setting
= bold print
Explanation
Configuration
Wayofmounting
0to1
0
Lintelmountingonhingesidewithslidechannel,pull-version
1 Lintelmountingonoppositehingesidewithstandardarm,
push-version
Linteldepth
ED 100: -3 to 30
ED 250: -3 to 50
0
Thelinteldepthisadjustedinstepsof10mm.
Considertheinstallationdrawingstofindtherequireddimension.
Door-leafwidth
ED 100: 7 to 11
ED 250: 7 to 15
10
Therebateisincludedinthedoor-leafwidth.
Thedoorwidthisindicatedinstepsof100mm.
Doortype
0to4
0
Single-leafdoor
1 Double-leafdoor,activeleaf,withrebate(overlapping)
2 Double-leafdoor,passiveleaf,withrebate(overlapping)
3 Double-leafdoor,activeleaf,withoutrebate
4 Double-leafdoor,passiveleaf,withoutrebate
Driving parameters and functions
Openingspeed
ED 100: 8 to 50
ED 250: 8 to 60
(inLow-Energy
Modereduced
to25°/sec.
respectively)
Degrees/
Second
25
TheopeningspeedreferstoAutomaticmode.Abidebycountry-
specificlimitsandcheckafteradjustment.Thefulladjustablerange
isonlyavailablewhentheUpgradeCardFull-Energyisinstalled.You
canalsoadjustthespeedviathisparameter.Aninternalmonitoring
functionchecksiftheselectedadjustmentsareadmissible.Incase
theadjustedparameterexceedstheadmissiblevalue,theadjusted
andtheoperativevaluearedisplayedalternately.
Closingspeed
ED 100: 8 to 50
ED 250: 8 to 60
(inLow-Energy
Modereduced
to25°/sec.
respectively)
Degrees/
Second
25
TheclosingspeedreferstoAutomaticmode.Abidebycountry-
specificlimitsandcheckafteradjustment.Thefulladjustablerange
isonlyavailablewhentheUpgradeCardFull-Energyisinstalled.Also
thespeedcanbeadjustedviathisparameter.Aninternalmonitoring
functionchecksiftheselectedadjustmentsareadmissible.Incase
theadjustedvalueexceedstheadmissiblevalue,theadjustedandthe
operativevaluearedisplayedalternately.

Other manuals for Dorma ED 100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dorma ED 100 and is the answer not in the manual?

Dorma ED 100 Specifications

General IconGeneral
Adjustable Closing SpeedYes
Latching SpeedAdjustable
TypeElectromechanical
Power Supply230 V AC, 50 Hz
Fire RatedYes
BackcheckAdjustable
Delayed ActionAdjustable
Hold-Open FunctionYes
FinishSilver

Related product manuals