Introduction & Safety -2
Version 1.36
02/2004
Safety
General remark concerning safety
This subsection is intended as an overview of the warnings and instructions used in this manual that must
always be observed.
The following general safety precautions apply to the operation and maintenance of the machine and must
always be observed. Non-observance of these instructions or any other safety precautions mentioned in this
manual could impair the machine safety standards, lead to dangerous situations, and the manufacturer
cannot be held responsible for possible damages.
Service technicians must thoroughly read and understand the Service Manual and operating instructions
before they can install the dispenser and put it into operation.The service technician must hand over and
explain the operating instructions to the customer.
Installation, startup, programming and, if required, repair of the dispenser must be performed by trained and
authorized service technicians only.
Hazard intensity levels
There are three different levels of hazard intensity, identified by signal words DANGER, WARNING and
CAUTION. The level of hazard is determined by the following definitions;
DANGER Sudden hazards, that WILL lead to either serious personal injury or death.
WARNING Hazards due to dangerous behaviour that CAN lead to either serious injury or death.
CAUTION Hazards due to dangerous behavior that can lead to either minor injury to persons
or damage to product.
In addition the following symbols have been added throughout the service manual to
emphasize safety measures related to a specific action.
Pay particular attention to the remark preceeded by this symbol.
General warning
Risk of electric shock
Risk of contact with (very) hot liquids or objects.
To Next Page
Loading...
