AEF-A.DOC 02/2003
18
5.3 – EVERY 6 MONTHS
5.3.1 – CONTROL OF BELT’S STRETCHING
It is necessary to control the belts’ stretching every 6 months in all transmissions. If the belts
are too loose, the machine will lose power.
a) The transmission’s belts of the spiral can be examined by opening the cover of the
machine.
b) The transmission’s belts of the bowl can be examined by removing the access panel
on the bottom side of the machine.
c) To verify if the belt needs to be stretched, press a finger in the middle of the belt, and
if the looseness is superior to ½" (1 cm), there is a need to stretch it.
d) To stretch it, it is necessary to call an authorised technician.
To Next Page
Loading...
