AEF-A.DOC 02/2003
15
4.5.2 – CHANGING PROGRAMMED TIME DURING WORKING CYCLE.
• At any time during the working cycle, you can change the programmed time, by using
the buttons 11[
] or 12[ ]. This change only works for this period, that
means that at the end of the cycle, the program will return to the original values.
4.5.3 – STOP
• At any time, during the working cycle, you can stop the sequence, by pressing the stop
button 16 [
]. If you press the button 15[ ], the machine will resume the
work, but if you press continuously the stop button 16 [ ], you’ll get out of the
program.
• When the working cycle is completed the stop button 16 will light. Then, if you press it,
the cycle will end and the equipment is ready to start a new working cycle.
4.5.4 – SECURITY BARS
• If you lift up the safety bars during the working process, the machine will stop, and give
a sonorous signal.
• To restart the process, close the security bars and press again the start button 15
[ ].
4.6 – PROGRAMMING THE WORKING TIME
!
You can program 50 different programs, with time V1 and V2.
!
To program you must:
• Put the machine in automatic mode by pressing button 7 [ ].
• With buttons 11 [ ] and 12 [ ], select the program.
• For example, program 2.
To Next Page
Loading...
Need help?
General
