Dräger Infinity M540 - Biomed Setup - Network Setup

System configuration
476 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Biomed setup – network setup
The following table lists the available settings for
configuring the Infinity and the hospital network
settings in the Infinity and the Hospital pages. To
access the pages, see page 470. After making the
desired changes, select the Apply button to
activate them.
Selection Available settings Description
DHCP – Disabled (default)
– Enabled
Applies to the hospital network.
When the Dynamic Host Configuration
Protocol (DHCP) is activated, the settings for
IP address, Subnet mask, Gateway, and
Primary DNS are pulled automatically from
the server.
IP address User selectable Allows you to select an IP address manually
(the DHCP setting has to be set to Disabled).
Subnet mask User selectable Allows you to set up a subnet mask (the DHCP
setting has to be set to Disabled).
Gateway User selectable Allows you to set up a gateway (the DHCP
setting has to be set to Disabled).
Primary DNS User selectable Allows you to set up the primary Domain Name
System (DNS) – set the DHCP setting to
Disabled.
Offline detection – On (default)
–Off
Determines if the Cockpit issues an alarm tone
and a message when it loses its connection to
the Infinity network. For more information, see
"Communicating with the Infinity network"
on page 48.