Dräger Interlock XT User Manual

21
Faults, Cause and Remedy
Display Cause Remedy
Flow detected during Warm-Up Breath sample has been blown too early Deliver breath sample when requested by the instru-
ment.
Blow stronger ! / Repeat Test Breath sample has been blown too soft Repeat test blowing stronger.
Blow softer ! / Repeat Test Breath sample has been blown too strong Repeat test blowing softer.
Blow longer ! / Repeat Test Breath sample has been blown too short Repeat test blowing longer.
Suck after Blow / Repeat Test Breath sample is not delivered correctly
by blowing and sucking
Repeat test with blowing and immediately afterwards
sucking.
Suck longer ! / Repeat Test Breath sample has been sucked too short Repeat test sucking longer.
Check mouthpiece / Repeat Test Mouthpiece is not correctly inserted into
handset
Insert mouthpiece correctly.
Please retry / Repeat Test During delivery of the breath sample a
fault has been detected
Deliver breath sample again when requested by the
instrument.
Test Failed The measured breath-alcohol concentra-
tion is above the set limit value
Repeat test after at least 15 minutes.
If message reappears, the breath alcohol concentra-
tion is above the limit value.
Low Temperature / Warm Up Handset Temperature of the handset too low Detach handset and take it at a place with moderate
temperature. Connect measuring instrument again and
make measurement.
High Temperature / Cool down Handset Temperature of handset too high Detach handset and take it at a place with moderate
temperature. Connect measuring instrument again and
make measurement.
Service required in x days Service interval will expire in x days Call an authorized Dräger Interlock Service Center in
due time.
Service lockout Service interval expired Call an authorized Dräger Interlock Service Center.

Dräger Interlock XT Specifications

General

Brand	Dräger
Model	Interlock XT
Category	Measuring Instruments
Language	English