The DragonLink transmitter is capable of providing a range of audible warnings to the
user.
Missing PPM: Triggered by a loss of input from the radio controller’s trainer jack or
module bay connection.
Low TX voltage: User-configurable low input-voltage alarm.
Low flight voltage: Triggered by low voltage reading from optional DragonLink Voltage
Sensor (requires active telemetry link).
Low RX RSSI: User-configurable low signal strength alarm.
Change power level: Either one, two, or three beeps will be played to correspond
with the selection of either low, mid, or high power levels, respectively. When using
Auto power level modes only, disabling this alert is recommended (see section
4.1.3).
Micro Power mode*: Plays a repeating audio reminder while the transmitter is in
micro power (range test) mode.
Servo test mode*: Plays a repeating audio reminder while the transmitter is in servo
test mode.
Bind mode*: Plays a repeating audio reminder while the transmitter is in bind mode.
* It is recommended that these reminders be enabled to ensure the model aircraft is
not inadvertently launched while the transmitter remains in a mode that may cause
loss of control or damage.
To Next Page
Loading...