In normal conditions, the range test should yield a distance of approximately 10
metres, or 30 feet. 5 metres, or 15 feet, is acceptable for shorter range craft that will
operate up to a maximum distance of 5km.
3.3.2 Bind Mode
It is possible to bind the transmitter to the receiver without using the DragonLink
GUI. To do so,
1. Ensure the receiver is powered off.
2. Hold down the Menu button on the DragonLink transmitter and turn on the
power.
1. After the power-on sound is played, continue to hold the menu button until the
LED(s) on the transmitter turn blue accompanied by 2 beeps.
2. Release the Menu button.
3. The transmitter will continue to play 2 beeps (if the bind mode alarm is enabled)
and the LED(s) will flash blue to indicate it is in binding mode.
4. Power on the receiver.
5. The receiver’s blue and green LEDs should both begin flashing to indicate a
successful bind.
6. Power off both the receiver and the transmitter to save the binding.
3.3.3 Servo Test
In servo test mode, the DragonLink transmitter will continuously sweep all channels
back and forth from minimum to maximum positions.
1. Hold down the Menu button on the DragonLink transmitter and turn on the
power.
2. After the power-on sound is played, continue to hold the menu button until the
LED(s) on the transmitter turn yellow accompanied by 3 beeps.
3. Release the Menu button.
4. The transmitter will continue to play 3 beeps (if the servo test mode alarm is
enabled) and the LED(s) will flash yellow to indicate it is in servo test mode.
5. To exit servo test mode, press the menu button.
To Next Page
Loading...