WARNING: Changing the USB function setting will prevent the
DragonLink GUI from being able to connect to the transmitter for
configuration purposes. See section 3.3.5 for instructions on how to
change this setting back to the default.
Passes raw serial data directly to and from the
connected device.
Encodes non-MavLink telemetry from the aircraft
into a MavLink-compatible telemetry stream for use
with ground stations.
Allows the connected device to configure the
transmitter using the DragonLink GUI
NOTE: Baud rates do not apply to the USB virtual COM port. As long as
the baud rate is correct on the receiver, and the receiving software
matches that setting, the data will parse successfully.
Enable MavLink decoding: This setting enables decoding of an incoming MavLink
telemetry stream so that certain sensor values can be passed to external, non-
MavLink devices.
To Next Page
Loading...