Drayton LP10RF - The Standard Program

Client Drayton File Name 75 42 Dr ayt on LP 10R F & DIG IS TAT+2 RF 06 515 08 600 1 ISS C
Artworker -
Proof Stage
PRINT
Finished Size A5 148x210mm
Creative Director Mike Lane Artwork % 100%
Modification Date 21/08/15 2:56PM Bleed 3mm
User Guide LP10RF Programmer & Receiver
LP10RF

NOTE:
The ON/OFF periods pre-programmed for Hot
Water pre-heat are shown in the table opposite. The
factory installed settings can be used without any
further programming of the receiver. The date and
time are pre-programmed and should not require
adjustment.
If you need to restore the factory pre-set program
times then:
Press the + and - buttons together, for three seconds or
longer, to restore the default program times to those
shown in the table opposite.
Switching
Weekdays Weekends
HW HW
1st ON - start of rst timed period 6.30am 7.00am
1st OFF - end of rst timed period 8.30am 9.00am
2nd ON - start of second timed period 12.00pm 12.00pm
2nd OFF - end of second timed period 12.00pm 12.00pm
3rd ON - start of third timed period 4.30pm 4.00pm
3rd OFF - nal swith-off of the day 10.30pm 11.00pm

NOTE:
Two ON/OFF periods can be used instead of three,
by setting the second ON/OFF periods to 12:00 as
shown in the default program table.
One ON/OFF period can be achieved by setting the
second and third ON/OFF periods to the same time.
See Changing the Program on the next page, if changes
are required to the clock time or pre-programmed
settings.
The Standard Program
21LP10RF & DIGISTAT+2RF
06515086001 ISSC