Dreame H12 Core User Manual

18
EN
Troubleshooting
Error Possible Cause Solution
No wateris
comingout
oftheappliance.
The Clean Water Tank is not
properly installed in place, or
the water in the Clean Water
Tank is insu󶀆cient.
Re-install or 󶀄ll the Clean
Water Tank.
It takes 30 seconds to dampen
the brush roller.
Turn on the appliance and
check again in 30 seconds.
The vent leaks
water.
A collision or a sharp pull
causes water to enter the
motor.
Movethe appliancegently
back and forthwhile itis
turned on.
The󶀄lteris not completely dry
after being cleaned.
Dry the 󶀄lter completely
before use.
Self-cleaning
fails.
The brush roller may be
jammed by largedebris.
Remove the brush roller
cover to check and clean the
brush roller.
The appliance is not placed
onto the charging base
properly.
Make sure the appliance
is being charged before
enabling the self-cleaning
function.
Self-cleaning cannot be
enabled if the battery level is
lower than 20%.
The self-cleaning function
canonlybe enabledwhen
the appliance is being
charged and the battery level
is more than 20%.
TheUsed Water Tankis not
installed in place, or theUsed
Water Tankis full.
Re-install or empty theUsed
Water Tank.
The Clean Water Tank is not
installed in place, or the water
in the Clean Water Tank is
insu󶀆cient.
Fill or re-install theClean
Water Tank.

Dreame H12 Core Specifications

General

Battery Capacity	4000 mAh
Clean Water Tank Capacity	900 ml
Dirty Water Tank Capacity	500 ml
Display	LED
Self-Cleaning	Yes
Power	200 W
Type	Cordless Wet and Dry Vacuum Cleaner
Dustbin Capacity	Not applicable
Cleaning Modes	Auto, Max
Run Time	35 minutes
Charging Time	4-5 hours