Dreame H12 Pro - Cleaning the Tube and the Dirt Sensor; Cleaning the Brush Assembly

17
Cleaning the Tube and the Dirt Sensor
Remove the Used Water Tank, gently wipe the tube and the dirt sensor with a wet cloth
before use.
Note: Do not rinse the tube or the dirt sensor.
Cleaning the Brush Assembly
1. First, press the brush roller cover
release button inwards on both sides
to remove the brush roller cover.
Press the brush roller release button,
and the brush roller handle will pop
out. Pull it to take out the brush
roller.
2. Clear the hair and debris tangled on the
brush roller with the provided cleaning
brush. Rinse the brush roller with clean
water. Air dry the brush roller
thoroughly or dry it by activating the
drying mode several times-.
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
4. Re-install the brush roller and the
brush roller cover until you hear a click.
Note
• Clean as needed. Alternating use of the two provided brush roller is
recommended.
• Replacing the brush roller every 3 to 6 months is recommended.
Dirt Sensor