Drive 15005LP - Electromagnetic Compatibility (EMC); EMC Precautions

7
This MEDICAL ELECTRICAL EQUIPMENT needs special precautions regarding EMC and needs to be installed and put
into service according to the EMC information provided in the table below.
Portable and mobile RF communications equipment can affect MEDICAL ELECTRICAL EQUIPMENT
!
ELECTROMAGNETIC EMMISSION AND IMMUNITY
WARNING
The use of ACCESSORIES, transducers and cables other than those specied, with the exception of transducers and
cables sold by the manufacturer of the EQUIPMENT or SYSTEM as replacement parts for internal components, may
result in increased EMISSION or decreased IMMUNITY of the EQUIPMENT or SYSTEM.
Below cables information are provided for EMC reference
Cable Max. cable length,
Shielded/unshielded
Number Cable classication
AC Power Line 3.8m Unshielded 1 Set AC Power
!
WARNING
Important information regarding Electro Magnetic Compatibility (EMC)
FULL ELECTRIC & SEMI ELECTRIC BEDS require special precautions regarding EMC when put into service according
to the EMC information provided in the user manual and special precautions need to be observed:
FULL ELECTRIC &SEMI ELECTRIC BEDS with no ESSENTIAL PERFORMANCE is intended for use in a professional
healthcare facility environment and homecare environment.
WARNING: Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm (12 inches) to any part of the SEMI ELECTRIC BED WITH MANUAL LEG
ADJUST, including cables specied by the manufacturer. Otherwise, degradation of the performance of this equipment
could result.
The use of accessories and cables other than those specied by Drive DeVilbiss Healthcare, with the exception of
accessories and cables sold by Drive DeVilbiss Healthcare for use with the FULL ELECTRIC & SEMI ELECTRIC BEDS
as replacement parts for internal components, may result in increased EMISSIONS or decreased IMMUNITY.
WARNING: Use of this FULL ELECTRIC & SEMI ELECTRIC BEDS adjacent to or stacked with other equipment should
be avoided because it could result in improper operation.