Drive 15571 - MAINTENANCE & SAFETY CHECKS; ELECTRONICS; BED FRAME & SLEEPING SURFACE; CLEANING

34
Drive recommends the following maintenance and cleaning procedures be conducted between users.
ELECTRONICS
• Check all controls to make sure all functions work properly.
• Foot control
• Head control
• Check all cables for damaged or frayed wires.
• Power cord
• Pendant cord
• Check to make sure all plugs are fully inserted or attached.
• Check 9V battery on pendant and motor and replace annually.
BED FRAME & SLEEPING SURFACE
• Visually check all welds.
• Head section
• Foot section
• Main Frame
• Check joints between sleeping surface sections for loose fasteners.
CLEANING
• If possible, remove patient/resident before cleaning bed.
• Prior to cleaning unplug power supply cord
• Ensure all electrical parts (motors, control boxes, wires and pendant) are not broken. Ensure that NO liquids enter
electrical components.
• The metal parts of the bed are covered with a powder coating. Clean all coated parts with mild detergent and warm
water.
• Raise head and foot sections of the bed to remove dust from frame.
• Remove mattress and clean mattress deck.
• Remove all gross/solid contaminants, then wash and sanitize all components. DO NOT submerge the bed frame or
electrical components.
• Solvents, alcohol, bleach, caustic agents, high acid or alkaline solutions or petroleum based products should not be
used on the bed.
• Use standard water pressure. DO NOT power wash or steam clean any parts.
• Rinse completely with water (Maximum temperature 110
o
F or 43
o
C). Do not rinse with cold water.
• Ensure all parts are dry before using or storing.
NOTE: This bed is NOT compatible with wash down tunnels.
LUBRICATION & MECHANICAL
• Lubricate all caster roller and swivel bearings with light machine oil.
• Check all bolts and tighten as needed.
WARRANTY
• Lifetime warranty on welds and frame.
• 5 year warranty on motor and hand control.
• 1 year warranty on all other parts and components.
During the warranty period, defective items will be repaired or replaced at Drive’s option at no charge.
NOTE: The Competitor II bed can be used with a free standing trapeze or a Drive Medical frame mounted trapeze
(Item# 13009KT-BV).
MAINTENANCE & SAFETY CHECKS