DS Automobiles DS 4 User Manual

05
175
Safety
Your vehicle has been approved in accordance
with the latest ISOFIX regulation.
The seats, represented below, are fitted with
regulation ISOFIX mountings:
"ISOFIX" mountings
There are three rings for each seat:
- a ring B, located behind the seat and
identified by a marking, referred to as the
Top Tether for fixing the upper strap.
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted with two
latches which are secured on the two rings A.
Some seats also have an upper strap, known
as the Top Tether, which is attached to ring B.
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
Strictly follow the fitting instructions provided in
the user guide supplied with the child seat.
For information on the possibilities for installing
ISOFIX child seats in your vehicle, refer to the
summary table.
When fitting an ISOFIX child seat to the
left-hand rear seat of the benchseat,
before fitting the seat, first move the
centre rear seat belt towards the middle
of the vehicle, so as to avoid the seat
interfering with the operation of the
seat belt.
- pass the upper strap of the child seat
behind the seat backrest, centring it
between the apertures for the head
restraint rods,
- fix the hook of the upper strap to the ring B,
- tighten the upper strap.
To secure the child seat to the TOP TETHER:
- remove and stow the head restraint before
installing the child seat on the seat (refit it
once the child seat has been removed),
- two rings A, located between the seat
backrest and cushion, indicated by a
marking,

DS Automobiles DS 4 Specifications

General

Brand	DS Automobiles
Model	DS 4
Category	Automobile
Language	English