03
96
Ease of use and comfort
F Turn the knob to obtain the desired level of
lumbar support.
F Press the front or rear of the control to
obtain the desired lumbar support.
F Press the switch to activate the function.
The warning lamp on the switch comes on and
the massage function is activated for a period
of 60 minutes. During this time, massage is
performed in 6 cycles of 10 minutes each cycle
(6 minutes of massage followed by 4 minutes
break).
After an hour, the function is automatically
deactivated. The warning lamp in the switch
goes off.
Deactivation
You can deactivate the massage function at
any time by pressing the switch. The movement
in progress continues until the initial non-
massage position is reached.
Massage function
Manual lumbar adjustment Electric lumbar adjustment
This function provides a back massage; it only
operates when the engine is running.
To Next Page
Loading...
Need help?
General
