07
242
Practical information
Bonnet
Opening
F Pull the interior bonnet release lever A,
located at the bottom of the door aperture.
F Push the exterior safety catch B to the left
and raise the bonnet.
F Unclip the stay C from its housing on the
back of the bonnet.
F Fix the stay in the notch to hold the bonnet
open.
The location of the interior bonnet
release lever prevents opening of
the bonnet while the front left door is
closed.
Do not open the bonnet in high winds.
When the engine is hot, handle the
exterior safety catch and the bonnet
stay with care (risk of burns).
Before doing anything under the
bonnet, deactivate the Stop & Start
system to avoid any risk of injury
resulting from an automatic change to
START mode.
Closing
F Take the stay out of the support notch.
F Clip the stay in its housing on the back of
the bonnet.
F Lower the bonnet and release it at the end
of its travel.
F Pull on the bonnet to check that it is
secured correctly.
The cooling fan may start after switching
off the engine: take care with articles and
clothing that might be caught by the fan
blades.
Because of the presence of electrical
equipment under the bonnet, it is
recommended that exposure to water
(rain, washing, ...) be limited.
F Open the front left door.
To Next Page
Loading...
Need help?
General
