08
271
In the event of a breakdown
Spare wheel
Procedure for changing a wheel with a damaged or punctured tyre for the spare wheel, using the tools supplied with the vehicle.
The tools are installed in the boot under the
floor.
To gain access to them:
F open the boot,
F raise the floor,
F secure it by hooking its cord on the hook
on the rear shelf support,
F with a standard size spare wheel, unclip
and remove the box in the middle of the
wheel containing the tools,
or
F with a "space-saver" spare wheel; lift the
wheel at the rear towards you for access to
the storage box containing the tools.
Access to the tools
1. Wheelbrace.
For removing the wheel trim and the wheel
fixing bolts.
2. Jack with integral handle.
For raising the vehicle.
3. Bolt cover removal tool.
For removing the bolt head protectors on
alloy wheels.
4. Socket for the security bolts (located in the
glove box).
For adapting the wheelbrace to the special
"security" bolts.
All of these tools are specific to your
vehicle and can vary according to
equipment.
Do not use them for any other
purposes.
The jack must only be used to change
a wheel with a damaged or punctured
tyre.
Do not use any jack other than the one
supplied with this vehicle.
If the vehicle does not have its original
jack, contact a CITROËN dealer or a
qualified workshop to obtain the correct
jack for it.
The jack meets European standards,
as defined in the Machinery Directive
2006/42/CE.
The jack does not require any
maintenance.
List of tools
To Next Page
Loading...
Need help?
General
