EasyManua.ls Logo

DS Automobiles DS 4

DS Automobiles DS 4
421 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
08
270
In the event of a breakdown
Checking / adjusting tyre pressures
You can also use the compressor, without
injecting sealant, to check and if necessary
adjust the tyre pressures
F Remove the valve cap from the tyre and
place it in a clean area.
F Uncoil the pipe stowed under the
compressor.
F Check that the compressor switch is at
the "O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
F Start the compressor by placing the switch
at the "I" position and adjust the pressure
to the value shown on the vehicle's tyre
pressure label.
To deflate: press the black button on the
compressor pipe, at the valve connector.
F Once the correct pressure is reached, put
the switch to the "O" position.
F Remove the kit then stow it.
F Connect the compressor's plug to the
vehicle's 12 V socket.
F Switch on the ignition.
F Screw the pipe onto the valve and tighten
firmly.

Table of Contents

Related product manuals