9
.
Factory Defaults Reset
You can reset the programming options for the Communicator to the factory settings by installing the hardware jumper. Perform
the following steps to reset the Communicator:
NOTE: Two pins require a jumper in order to reset the hardware values.
1. Remove panel front cover.
2. Locate the AUDIO/DEFAULT five pin connector in the middle of the Communicator board. On the PC1616/1832/1864 panels
pins 4 and 5 are on top. (See Figure 3). On the PC9155 panel, pins 4 and 5 on right. See Figure 5).
3. Apply a jumper to short the hardware default pins 4 and 5 together.
4. Remove all power from the panel and then apply power to the panel. Wait until the two green LEDs on the Communicator begin
flashing rapidly. (The Green LEDs will continue to flash as long as the hardware jumper is connected).
5. Remove the jumper from the hardware default pins 4 and 5. (Green LEDs will stop flashing).
NOTE: Your Communicator has now been reset to the factory default values.
Firmware Update
The firmware of the device can be updated over GPRS or Ethernet. (Remote or Local updating).
• When the firmware update begins, all LEDs are ON.
• During the firmware update process, the LEDs will be cycled individually in a chaser pattern.
• After a successful update the unit will automatically restart.
• Should the update fail, all 4 LEDs will flash ON, then OFF together at 1 second intervals.
• If the firmware update fails, restart the unit. In the event of consistent update failures, contact your dealer.
Network Data Usage
NOTE: With encryption and supervision on, all packets are 149 bytes.
COMMUNICATOR RESET / UPDATE / NETWORK DATA USAGE
Table 6: Network Data Usage
PACKET TYPE DIRECTION BYTES PACKET TYPE DIRECTION BYTES
Init Communicator to Receiver 101 Bytes Contact ID ACK Receiver to Communicator 49 Bytes
Init ACK Receiver to Communicator 74 Bytes Heartbeat 1 Communicator to Receiver 101 Bytes
SIA -Single Event Communicator to Receiver 124 Bytes Heartbeat 1 ACK Receiver to Communicator 74 Bytes
SIA -6 Events Communicator to Receiver 149 Bytes Heartbeat 2 Communicator to Receiver 60 Bytes
SIA ACK Receiver to Communicator 77 Bytes Heartbeat 2 ACK Receiver to Communicator 60 Bytes
Contact ID Event Communicator to Receiver 70 Bytes Encryption and Supervision Enabled Both Directions 149 Bytes
To Next Page
Loading...
