Event [Section] Label Default Label Event [Section] Label Default Label
[838] Delinquency (Delinquency) [839] Keypad Lockout (Keypad Lockout)
[840] Event Log 75% full (Buffer Near Full) [841] FTC Trouble (Fail to communicate trouble)
[842] FTC Restore
(fail to communicate
restore)
[843] Panel Absent Trouble
(Panel Communications
Trouble)
[844] Panel Absent Trouble
Restore
(Panel Communications
Restore)
[845] Module
Reprogramming
(Communicator
Programming Updated)
[846] Firmware Update
(Communicator Firmware
Updated)
[850] Module (Module)
[851] Stay Arm (Stay Arm) [852] Away Arm (Away Arm)
[853] Night Arm (Night Arm) [854] Disarm (Disarm)
[855] Activate Command
Output 1
(Activate Command Output
1)
[856] Activate Command
Output 2
(Activate Command Output 2)
[857] Activate Command
Output 3
(Activate Command Output
3)
[858] Activate Command
Output 4
(Activate Command Output 4)
[859] Deactivate Command
Output 1
(Deactivate Command
Output 1)
[860] Deactivate Command
Output 2
(Deactivate Command Output
2)
[861] Deactivate Command
Output 3
(Deactivate Command
Output 3)
[862] Deactivate Command
Output 4
(Deactivate Command Output
4)
[863] Bypass (Bypass) [864] Unbypass (Unbypass)
[865] Status Request (Status Request) [866] Alarm Memory Request (Alarm Memory Request)
[867] Help (Help)
[868] Pay As You Go Balance
Request
(Balance Request)
[869] Keypad Message (Keypad Message) [870] Function Successful (Successful)
[871] Function Failure (Unsuccessful) [872] Invalid Command (Invalid Command)
[873] System Stay Armed (Stay Armed) [874] System Away Armed (Away Armed)
[875] System Night Armed (Night Armed)
[876] System Disarmed
Ready
(Disarmed Ready)
[877] System Disarmed, Not
Ready
(Disarmed Not Ready) [878] System In Alarm (is in Alarm)
[879] Trouble Label (Service is Required) [880] No Alarms in Memory (No Alarms in Memory)
[881] Pay As You Go Balance (Pay as you go balance:) [882] Pay As You Go Message (*123#)
[883] Response Code (Response Code)
Receiver Diagnostic Testing
[901] Diagnostic Test Transmission
[1] Ethernet 1 Default (OFF).
[2] Ethernet 2 Default (OFF).
[3] Cellular 1 Default (OFF).
[4] Cellular 2 Default (OFF).
[5],[6],[7],[8] Reserved (OFF).
This section may be used by the installer to force the communicator to send an immediate test transmission to specific receiv-
ers, to verify that the communications paths are available. Diagnostic test transmission failure will indicate as FTC trouble
(yellow LED = 9 flashes). Ifan FTC error occurs when testing all receivers, select only one receiver and repeat test to isolate
the receiver that is not communicating.
NOTE: Sending a test transmission to a receiver that is not programmed generates an FTC trouble.
46
To Next Page
Loading...
Need help?
General
