DSC LE2080 User Manual

[006] System Toggle Options 2
[1]- IPv6 control
ON - IPv4v6 Enabled. This option may be required by certain network providers. It is enabled at default in LTE com-
municators for LATAM, Europe and Australia
Off - IPv4 Only.This option is disabled at default in North American LTE communicators.
[5] - Radio Not In Use (v5.6+)ON - Radio Not In Use - The cellular radio will be disabled, preventing any trouble conditions
related to cellular from being indicated. This option applies to LATAM, European and Australian communicators and has
no effect in NA products.Enable this if no SIM card is being used with the communicator.
Off - Radio in Use
[7] DLS Over Cellular. Default (ON).
ON: DLS is enabled on the cellular path.
OFF: DLS is disabled on the cellular path.
NOTE: Program this toggle as OFF to prevent DLS from using the cellular path.
NOTE: If this toggle is OFF, DLS sessions will occur on the Ethernet path only, regardless of the primary path set in section
[005] toggle option [4]. If it is ON, the communicator will connect to the primary path first for DLS and if the session
fails, the secondary path will be used.
[8] Network Trouble Suppression. Default (OFF).
ON: GSM/Ethernet/Supervisory troubles and restore signals follow delay timer as programmed in section [226].
OFF: GSM/Ethernet/Supervisory troubles and restore signals are sent immediately.
[007] Primary Ethernet DNS IP
Default (000.000.000.000)
Enter the IP address for DNS server 1. Format is 4 fields, each field is a 3-digit decimal. Valid range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP server will configure the address. If an address is pro-
grammed and DHCP is used, the programmed address will be used instead of the DHCP address.
[008] Backup Ethernet DNS IP
Default (000.000.000.000)
Enter the IP address for DNS server 2. Format is 4 fields, each field is a 3-digit decimal. Valid range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP server will assign this value. If an address is programmed
and DHCP is used, the programmed address will be used instead of the DHCP address.
[009] Language
Default (01)
Opt Language Opt Language Opt Language Opt Language
01 English 09 Finnish 17 Not Used 25 Ukrainian
02 Spanish 10 German 18 Croatian 26 Slovakian
03 Portuguese 11 Swedish 19 Hungarian 27 Serbian
04 French 12 Norwegian 20 Romanian 28 Estonian
05 Italian 13 Danish 21 Russian 29 Slovenian
06 Dutch 14 Hebrew 22 Bulgarian 30-99 Reserved
07 Polish 15 Greek 23 Latvian
08 Czech 16 Turkish 24 Lithuanian
NOTE: Programming this section with an invalid language will default to English (01).
NOTE: After programming this section, perform a Default Language in section [999][11] to have programmable labels avail-
able in the selected language.
Programming Options
[010] System Toggle Options 3
[1] 2-Way Audio Over Cellular. Default (OFF)
ON: 2-Way Audio Over Cellular is enabled.
OFF: 2-Way Audio Over Cellular is disabled.
[2] Visual Verification. Default (OFF)
ON: Visual verification is enabled.
OFF: Visual verification is disabled.
24

DSC LE2080 Specifications

General

Brand	DSC
Model	LE2080
Category	Security System
Language	English