10
Programming codes from an LCD Keypad:
Master Code
Press the [
✱] key to enter the function list. Scroll (< >) to...
Press [5] or [
✱]. The displ ay will re ad...
Enter your current Master Cod e. The display will re a d...
“ 01P” represents the first a cc ess code. Use the arrow (< >) keys to scroll to “ 40P”
and press the [✱] key to indi cate that you wish to program the Master Cod e. The
displ ay will re ad...
Enter the new Master C ode. The Master C od e must be four di gits unless otherwise
indi c ate d by your installer. Enter di gits 0 through 9 only. O nc e the new cod e is
entere d, the keyp ad will b ee p 3 times and the displ ay will re ad...
Press [#] to exit the code programming function.
Be sure to re cord your new Master C ode on the “ System Information” page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
To erase, ad d or chang e a user cod e, press [
✱] to enter the functions list. Use the arrow (< >) keys to
scroll to the following message...
Press [
✱]. Display will re ad...
Enter the Master C ode. Displ ay will re ad...
Use the scroll keys (< >) to find the a c c ess code – indi cate d by “ 01P” to “ 32P” –
you wish to a d d, chang e or delete. Press the [
✱] key to sel ect the cod e you wish to
alter. The display will re ad...
To add or chang e a code, enter the new cod e. Acc ess cod es must be four digits
unless otherwise indi cated by your installer. Enter digits 0 through 9 only. To d elete
an acc ess cod e, enter [
✱]. O nc e the 4 digit code or [✱ ] has be en entere d, the
keyp a d sound er will b ee p 3 times and the displ ay will re ad...
The “ P” means the code has been programmed. If there is no “ P” then that code is
deleted. Press [#] to exit the code programming function. Do not erase the Master code.
Remember to re cord your new code(s) on the “ System Information” pag e in this booklet.
Access Code Attributes
Ad ditional programmabl e attributes, such as zone bypassing c a p ability, can b e activate d or
de a ctivated for e a ch a c c ess code. For more information re garding ac c ess code attributes, ple ase
conta ct your installer.
Press (*) for<>
Access Codes
Enter Master
Access Code
[*] to Edit <>
User Code 01P
Enter New Code
1234 < >
[*] to Edit <>
User Code 01P
(*) to Edit < >
User Code 01P
Enter Master
Access Code
(*) to Edit < >
User Code 01P
Enter New Code
1234 < >
Press (*) for<>
Access Codes
To Next Page
Loading...
