DSC TL2803GR - Page 47

47
HSPA(3G) Alarm Communicator Installation Manual
[554] Armed
Default (Armed)
__________________________________
[555] Automatic Disarming
Default (Automatic Disarming)
__________________________________
[556] Automatic Arming
Default (Automatic Arming)
__________________________________
[557] Automatic Arming Cancelled
Default (Automatic Arming Cancelled)
__________________________________
[558] Late to Open
Default (Late to Open)
__________________________________
[559] Late to Close
Default (Late to Close)
__________________________________
[560] Disarmed After Alarm
Default (Disarmed After Alarm)
__________________________________
[561] Alarm Ocurred After Arming
Default (Alarm Ocurred After Arming)
__________________________________
[562] Exit Fault
Default (Exit Fault)
__________________________________
[563] Cold Start
Default (Cold Start)
__________________________________
[564] Armed With Zones Bypassed
Default (Armed With Zones Bypassed)
__________________________________
[565] Zone Bypassed
Default (Zone Bypassed)
__________________________________
[566] Zone Unbypassed
Default (Zone Unbypassed)
__________________________________
[567] Burglary Verified
Default (Burglary Verified)
__________________________________
[568] Burglary Not Verified
Default (Burglary Not Verified)
__________________________________
[569] Alarm Cancelled
Default (Alarm Cancelled)
__________________________________
[570] Holdup Verified
Default (Holdup Verified)
__________________________________
[571] Walk Test Begin
Default (Walk Test Begin)
__________________________________
[572] Walk Test End
Default (Walk Test End)
__________________________________
[573] System Test
Default (Test Message)
__________________________________
[574] Periodic Test Transmission
Default (Periodic Test)
__________________________________
[575] Periodic Test With Trouble
Default (Periodic Test With Trouble)
__________________________________
[576] DLS Remote Programming Begin
Default (Remote Programming Begin)
__________________________________
[577] DLS Remote Programming End
Default (Remote Programming End)
__________________________________
[578] SA Remote Programming Begin
Default (Remote Programming Begin)
__________________________________
[579] SA Remote Programming End
Default (Remote Programming End)
__________________________________
[580] Installer Lead In
Default (Local Programming Begin)
__________________________________
[581] Installer Lead Out
Default (Local Programming End)
__________________________________
[582] Firmware Update Begin
Default (Firmware Update Begin)
__________________________________
[583] Firmware Update Successful
Default (Firmware Update Successful)
__________________________________
[584] Firmware Update Fail
Default (Firmware Update Fail)
__________________________________
[585] Delinquency
Default (Delinquency)
__________________________________
[586] Keypad Lockout
Default (Keypad Lockout)
__________________________________
[587] Event buffer 75% full
Default (Event Buffer Near Full)
__________________________________
[591] FTC Trouble
Default (fail to communicate trouble)
__________________________________
[592] FTC Restore
Default (fail to communicate restore)
__________________________________
[593] Panel Absent Trouble
Default (Panel Communications Trouble)
__________________________________
[594] Panel Absent Trouble Restore
Default (Panel Communications Restore)
__________________________________