DSC TL2803GR - Page 48

48
HSPA(3G) Alarm Communicator Installation Manual
[595] Module Reprogramming
Default (Communicator Programming Updated)
__________________________________
[596] Firmware Update
Default (Communicator Programming Updated)
__________________________________
[600] Module
Default (Module)
__________________________________
[601] Stay Arm
Default (Stay Arm)
__________________________________
[602] Away Arm
Default (Away Arm)
__________________________________
[603] Night Arm
Default (Night Arm)
__________________________________
[604] Disarm
Default (Disarm)
__________________________________
[605] Activate Command Output 1
Default (Activate Command Output 1)
__________________________________
[606] Activate Command Output 2
Default (Activate Command Output 2)
__________________________________
[607] Activate Command Output 3
Default (Activate Command Output 3)
__________________________________
[608] Activate Command Output 4
Default (Activate Command Output 4)
__________________________________
[609] Deactivate Command Output 1
Default (Deactivate Command Output 1)
__________________________________
[610] Deactivate Command Output 2
Default (Deactivate Command Output 2)
__________________________________
[611] Deactivate Command Output 3
Default (Deactivate Command Output 3)
__________________________________
[612] Deactivate Command Output 4
Default (Deactivate Command Output 4)
__________________________________
[613] Bypass
Default (Bypass)
__________________________________
[614] Unbypass
Default (Unbypass)
__________________________________
[615] Status Request
Default (Status Request)
__________________________________
[616] Alarm Memory Request
Default (Alarm Memory Request)
__________________________________
[617] Help
Default (Help)
__________________________________
[618] Pay As You Go Balance Request
Default (Balance Request)
__________________________________
[619] Keypad Message
Default (Keypad Message)
__________________________________
[621] Function Successful
Default (Successful)
__________________________________
[622] Function Failure
Default (Unsuccessful)
__________________________________
[623] Invalid Command
Default (Invalid Command)
__________________________________
[624] System Stay Armed
Default (Stay Armed)
__________________________________
[625] System Away Armed
Default (Away Armed)
__________________________________
[626] System Night Armed
Default (Night Armed)
__________________________________
[627] System Disarmed Ready
Default (Disarmed Ready)
__________________________________
[628] System Disarmed, Not Ready
Default (Disarmed Not Ready)
__________________________________
[629] System In Alarm
Default (is in Alarm)
__________________________________
[630] Trouble Label
Default (Service is Required)
__________________________________
[631] No Alarms in Memory
Default (No Alarms in Memory)
__________________________________
[632] Pay As You Go Balance
Default (Pay as you go balance:)
__________________________________
[633] Pay As You Go Message
Default (*123#)
__________________________________
[634] Response Code
Default (Response Code)
__________________________________