DSE7200 / 7300 Series Operators Manual
77
6 OPERATION (STANDALONE)
The following description details the sequences followed by a module containing the standard ‘factory
configuration’.
Remember that if you have purchased a completed generator set or control panel from your supplier, the module’s
configuration will probably have been changed by them to suit their particular requirements.
Always refer to your configuration source for the exact sequences and timers observed by any particular module in
the field.
6.1 ALTERNATIVE CONFIGURATIONS
Depending upon the configuration of your system by the generator supplier, the system may have selectable
configurations (for example to select between 50Hz and 60Hz running). If this has been enabled your generator
supplier will advise how this selection can be made (usually by externally operated selector switch or by selecting
the required configuration file in the DSE7000 series front panel configuration editor).
To Next Page
Loading...
Need help?
General
