Need help?Do you have a question about the DSE DSE8610 and is the answer not in the manual?
Specifies the minimum and maximum voltage requirements for operation, including cranking.
Details the parameters for AC voltage and frequency measurement, including accuracy.
Specifies current sensing parameters, including CT ratings, VA burden, and accuracy.
Detailed description of all module terminals, pin assignments, cable sizes, and notes.
Illustrates common wiring configurations for 3-phase and 2-phase systems.
Overview of the control module's front panel layout, buttons, and display.
Details the function of each control button (Stop/Reset, Manual, Auto, Start, Mute) on the module.
Details the fully automatic operation of the generator, including start/stop sequences.
Describes manual control of the generator functions, including start/stop and load transfer.
Explains the warning alarm for generator high current and its escalation.
Lists critical alarm conditions that stop the generator and require manual reset.
Describes electrical trip conditions that stop the generator in a controlled manner.
Details overcurrent protection with warning and IDMT curve for thermal protection.
Describes protection against short circuits and earth faults using IDMT curves.
Steps to access the main configuration editor and edit parameters, including PIN entry.
How to access the editor while the engine is running to adjust parameters.
Recommended checks before the initial system start-up and wiring verification.
General| Brand | DSE |
|---|---|
| Model | DSE8610 |
| Category | Controller |
| Language | English |
To Next Page
