Specification
19
3.9.2 USB CONNECTION
The USB port is provided to give a simple means of connection between a PC and the DSE8600 series controller.
Using the DSE Configuration Suite Software, the operator is then able to control the module, starting or stopping
the generator, selecting operating modes, etc.
Additionally, the various operating parameters (such as output volts, oil pressure, etc.) of the remote generator are
available to be viewed or changed.
To connect a DSE8600 series module to a PC by USB, the following items are required:
• DSE8600 series module
• DSE 8600 series configuration software
(Supplied on configuration suite software CD or available from
www.deepseaplc.com).
• USB cable Type A to Type B.
(This is the same cable as often used between a PC and a USB printer)
DSE can supply this cable if required :
PC Configuration interface lead (USB type A – type B) DSE Part No 016-125
NOTE:- The DC supply must be connected to the module for configuration by PC.
NOTE:- Refer to DSE8600 series Configuration Suite Manual (DSE part 057-119) for further details on
configuring, monitoring and control.
3.9.3 USB HOST-MASTER (USB DRIVE CONNECTION)
Capability to add USB Host facility for USB ‘Pendrive’ type interface for data recording
Connector Type A.
For data logging max maximum size 16Gb.(see viewing the instrument pages)
NOTE:- Refer to DSE8600 series Configuration Suite Manual (DSE part 057-119) for further details on
configuring, monitoring and control.
CALL US TODAY
1-888-POWER-58
REQUEST A QUOTE
parts@genpowerusa.com
SHOP ONLINE
www.genpowerusa.com
To Next Page
Loading...
