Dual MXCP44 - Speaker Preparation;Installation; Speaker Installation Safety Precautions; Mounting and Securing the Speaker

12
MXCP44 OPERATION
Speaker Preparation/Installation
Please read entire manual before installation.
Before You Start
•Disconnectnegativebatteryterminal.Consultaqualifiedtechnicianforinstructions.
•Useextremecautionwhendrillingholestoavoiddamagingfuellines,hydrauliclines
orexistingwiring.
•Ifadditionalwiringisrequired,werecommendthatyourunallwirespriorto
mountingyourspeakerinplace.
•Usethehighestqualityconnectorsforareliableinstallationandtominimizesignal
andpowerloss.
•Usecautionbeforeyoudrillorcut!Becarefulnottocutordrillintogastanks,fuellines,
hydrauliclines,vacuumlinesorelectricalwiring.
•Avoidrunningwiresover,near,orthroughsharpedgedsurfaces.Wesuggestyou
also userubbergrommetstoprotectanywiresroutedthroughmetal.
Mounting and Installation
•Determinewherethespeakerswillbemounted.Ensureanarealargeenoughfor
thespeakertomountevenly.Besurethemountinglocationisdeepenoughforthe
speakertofit.
•Usinganappropriatetool,cuta5.13"diametermountinghole.
•Removegrillefromspeakerbyinsertingthereleasekeyintothelockingtabslots
locatedatthetopandbottomofthegrille.Gentlyapplypressuretowardsthecenter
ofthegrilletoreleasethelockingtabs.
•Usethespeakerasatemplatetomarkthelocationsforthemountingscrews.Drill
themountingscrewholeswitha1/8"pilotbit.Routespeakerwiresandconnectto
speakers,observingspeakerpolarity.
•Installspeakerintoopeningusingsuppliedhardwareandtestforcorrectoperation.
•Alignthespeakergrillelockingtabsandsnapgrilleintoplace.
RELEASE KEY