Replacing the high and low beam bulbs
Before replacing a burnt-out light, make sure that the
new one matches the voltage and wattage
specifications in paragraph "Electric System" page
242.
Always ensure that the new bulb you have installed
operates properly before refitting any parts you have
removed.
Figure shows the locations of the low beam (LO), high
beam (HI) and parking lights (1).
Headlight
The headlight is a full LED unit.
Important
Have the headlight lights replaced by a Ducati
Dealer or an Authorised Service Centre.
Warning
The headlight might fog up if the motorcycle is
used under the rain or after washing. Switch headlight
on for a short time to dry up any condensate.
Fig. 165
214
To Next Page