24
E
Procedure to override the immobilizer
using the throttle twistgrip
1) Turn the key to ON, then turn the twistgrip to fully open
the throttle and hold it open.
The EOBD warning light (5, fig. 6) will go off after
8 seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) The EOBD warning light will light up again and start
flashing. Now enter the electronic release code shown
on the CODE CARD given to the customer when the
motorcycle was handed over by the dealer.
4) Count a number of flashes of the EOBD light
equivalent to the first number of the secret code.
Open the throttle twistgrip, keep fully open for
2 seconds, then release. The digit entered is
acknowledged, and the EOBD light comes on and stays
on for the pre-set time of 4 seconds. Repeat the
operation until you have entered the final digit.
If no operation is performed with the throttle twistgrip,
the EOBD light will flash 20 times and then illuminate
steadily. In this case, repeat the procedure from step (1).
5) When you release the throttle grip, if the code has been
entered correctly the following two cases may occur:
A) the EOBD light starts flashing to indicate that engine
starting is now enabled. The light switches off
after 4 seconds, or if engine speed exceeds the
threshold value of 1000 rpm.
B) the IMMO warning light (3, fig. 5) flashes until the
engine speed rises above 1000 rpm, or until the
engine is re-started.
6) If the code is NOT entered correctly, both the EOBD
and IMMO lights stay on and the procedure can
be repeated starting again from step 2 as many times as
necessary.
Notes
If you release the twistgrip too soon, the warning
light will come on again. Return the ignition key to OFF
and repeat the procedure from step 1.
To Next Page