56
E
Movable nose fairing
Unscrew the four screws (1) securing the movable headlight
fairing to the brackets with the seal (2).
Remove the movable headlight fairing complete with the
windshield (fig. 44).
To replace the windshield, use the special torx wrench
to unscrew the screws (3) and nylon washers (4), while
holding the rubber coated nuts (5) in position from the
inside the fairing (fig. 45).
When fitting the new windshield, tighten the screws (2)
starting with the central screw.
Make sure that the seals (2) are correctly fitted to the
brackets, then fit the movable headlight fairing and
secure it with the screws (1).
Tighten the screws (1).
3
4
5
fig. 45
1
2
fig. 44
To Next Page