Procedure for adjusting the low beam/high
beam height
1) Switch on the low beam/high beam.
2) Fully cover and blank one of the two beams
3) Adjust the height of the visible beam by working
the corresponding screw adjuster (1), i.e., the
one located on the same side as the beam being
adjusted. Turn the screw (1) of the headlight
clockwise, the light beam will move downwards;
turn it counter clockwise to move beam up.
4) Cover the adjusted beam and uncover the other
one.
5) Adjust the height of the visible beam by working
the corresponding screw adjuster (1), i.e., the
one located on the same side as the beam being
adjusted. Turn the screw (1) of the headlight
clockwise, the light beam will move downwards;
turn it counter clockwise to move beam up.
Fig. 176
Warning
The headlight might fog up if the vehicle is used
under the rain or after washing. Switch headlight on
for a short time to dry up any condensate.
215
To Next Page